英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字，中文词皆可：

安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • How to properly drive an N-Channel mosfet with an ESP32
    From this YT video I learned that above certain loads for a P type mosfet the circuit has to change but I am using an N type so it should be fine Also that after certain frequencies the mosfet will behave differently if the off time is high enough to interfere with the next on cycle, but I am using the default frequency for the ESP32 which as
  • Why doesnt the MOSFET short when I apply a voltage greater than the . . .
    I have an IRF3205 MOSFET (datasheet): I have connected a power supply to the gate and source of the FET The maximum gate to source is 20V However, the FET is not damaged when I increase the gate
  • How can I turn a MOSFET on and off with a PNP transistor?
    I need to control a MOSFET (a Jiangshu JieJie JMSL0302AU) with an ATtiny1616 to turn a 40 A load on and off (without switching ) Could you please check if this schematic is correct? The ATtiny will
  • MOSFET symbol - what is the correct symbol - Electrical Engineering . . .
    I've been on this site now a couple of months and I notice various symbols used for MOSFETs What is the preferred symbol for an N Channel MOSFET and why?
  • How does this MOSFET-based Schmitt trigger work?
    This circuit is an inverting NMOS Schmitt trigger I have to admit, it took me a long time to figure out that this odd-looking diagram was actually showing the famous Otto Schmitt circuit Once I turned Q3 by 90 degrees counterclockwise, everything made sense What exactly does Q3 do and how does this circuit work? As you probably know, the classic Schmitt trigger consists of two source
  • When is a MOSFET more appropriate as a switch than a BJT?
    For an N-channel MOSFET (NMOS), for instance, which can switch current from Drain to Source, the body diode goes in the opposite direction, pointing from Source to Drain So, feel free to take advantage of this body diode when necessary, or just use the MOSFET as a diode directly
  • Reverse Voltage Protection with a P-channel MOSFET
    The way I see it, I can either connect the Drain-pin to the Input Voltage, or the Source-pin to the Input Voltage Does it matter which way I connect the P-channel MOSFET, or is the protection symmetric about the drain-source channel and all that matters is that the D-S channel is in series with the input voltage?
  • What do \$V_ {TN}\$ and \$V_ {T}\$ stand for in a MOSFET?
    What is the meaning and difference between the symbols: \$V_ {TN}\$ and \$V_T\$ commonly seen when talking about a MOSFET? I'm guessing \$V_ {TN}\$ is the threshold voltage, but what is \$V_T\$, and how do they relate to each other?
  • How to stabilize an op-amp with a MOSFET in the feedback loop
    The voltage reference at the top is about 3-5V lower than the supply voltages to the op-amp In the current circuit implementation I have a different MOSFET ZVP2106, which gives higher current and the sense resistor dropped to 50 3 Ohm
  • Do MOSFETs have a diode built into them?
    For single MOSFET circuits driving an inductive load, the body-diode will NOT work as a replacement for a flyback diode as it conducts in the wrong direction Consider for example an N-channel MOSFET as a low-side driver for a solenoid When the MOSFET turns off, the voltage spike at the drain will be positive





中文字典-英文字典  2005-2009