Bleeding the brakes and clutch | Honda VTX Forum Keep checking the reservoir so it doesn t get too low, otherwise it will allow air to be drawn in HINT: Get the reservoir on the handlebar level by temporarily loosening the handlebar and rotating it until the reservoir is close to level (but don t do this with the reservoir open) You ll have to loosen the four allen-head bolts on the risers
Brake reservoir - Honda VTX Forum Got a hole in the lower brake fluid reservoir by the rear brake pedal on an '06 VTX 1800 R Anyone know where I can get a replacement I'm in Pa a little south of Harrisburg if that helps any Thanks , riders
1800 Rear Brake Issues - Honda VTX Forum I know I do not need to bleed my car brakes unless I open the system or the reservoir gets to low and causes air to get in If there is an opening (loose fitting or cracked line), then fluid will leak out When I bled the rear brakes on the bike, the air came from the rear caliper and not from the front
Replace Rear briake reservoir | Honda VTX Forum Fellow VTXer's, I believe at least two people make a Rear briake reservoir that mounts on top of the master cylinder, eliminating that funky plastic jug and hose over the exhaust Anybody know who they are and which is the best? ******* :?
1800 Brakes: Bleeding Brakes and Clutch, Pad Wear Indicator 2) Reservoir No 2 is the remote brake fluid reservoir, located knee-high, at the right-hand side of the bike, just above the rear brake pedal It is used to flush the lower bleeder valves located on either side of the front-wheel brake calipers and the rear-brake bleeder, located on the rear wheel, at the top of the rear-brake caliper